1. Getting Started Guide

You are here:
Table of Contents

Virtual Machine Requirements

Cyberm8 Automation Platform is deployed as a virtual appliance.

The Required Virtual Machine Resources are:
100 GB Hard-drive
8 vCPU

Once you successfully deploy the virtual appliance, enter the virtual machine console and login using the default command-line credentials:

Username: cyberm8
Password: cyberm8

Setting Up The Network Configuration

By default, Cyberm8 Automation Platform will receive an IPv4 address from a DHCP server (if available). (You can view the current IP address using the ‘ifconfig’ command in command-line).

To set a new IP address enter the ‘Network Manager’ utility by typing: ‘csh net-config’. Use the ‘Network Manager’ to set IP Address, DNS, Static Routes (if required based on your network topology) and Hostname.

To apply the new network settings either ‘Deactivate’ and ‘Activate’ the connection in the ‘Network Manager’ utility (if connected via the VM Console), or by typing ‘csh network-restart’ in the command line.

Licensing Cyberm8

Connectivity from ‘Cyberm8 Automation Platform’ to ‘cyberm8.com’ on port 443, or through HTTP/S proxy as an un-authenticated user.

Proxy configuration: (if required)
To configure an HTTP/S proxy in ‘Cyberm8 Automation Platform’, run the command ‘csh set-proxy’ and follow the on-screen instructions.

To license the machine, enter the command ‘csh update-license-key’ and follow the on-screen instructions. You will be required to enter the license key supplied to you upon subscription.
After entering the license key, enter the command ‘csh license-check’ to validate the license.

After successfully licensing the machine you can log-in to the web interface and configure your automation processes by navigating to:
Default Web Interface Username: “admin”
Default Web Interface Password: “admin”